![]() ![]() This page gives you access to standard posts for common CNCs and controls. If you are new to machining, check out our online CNC Handbook. ![]() Before using a CNC make sure to follow the applicable safety instructions and guidelines. 3.1 When prompted to overwrite existing files choose “Accept”.Ĥ. Re-start Solidworks or Autodesk Inventor.ĥ. Re-open an existing SolidCAM or InventorCAM project file and confirm the changes made by generating the G-Code.Safety comes first so please be careful! This is machining and if something goes wrong you can lose your fingers, an eye, or break your CNC.zip folder then be sure to extract the files first by right clicking and selecting "Extract All". Standard install location for the GPPTOOL folder is: C:\Users\Public\Documents\SolidCAM\SolidCAM20XX\GPPTOOLĢ. Completely close down Solidworks or Autodesk Inventor.ģ. Open the email sent to you from a SolidCAM Tech Support representative and Save all of the attached files in the same location that you noted from Step 1.5 above. Post Processor files should be in a folder named “GPPTOOL”. 1.5 Verify where your saved location is at for your current post processor files by looking at the top box on the right under “Post-Processor files directory”.1.4 With the SolidCAM / InventorCAM settings open, select the “ Default CNC-Controller” page from the list on the left.1.3 For InventorCAM users: Open the InventorCAM settings by clicking on the “ CAM Settings” button located in the InventorCAM ribbon. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |